Drain pump Drain Major 60

Drain pump Drain Major 60Drain Major RTS60SL has been designed to pump waste water from a combination oven, dish glass washer. commercial sink basin or any situation where waste water needs to be collected and pumped to the drainage system. Pump: Safe to run dry 10 mm free passage with EIP technology Cooling jacket for motor housing SiC mechanical seal independent of sense rotation Replaceable moisture sealed cabinet inlet Flushing Device Fluid temperature 35C, temporarily

Drain Major RTS60SL has been designed to pump waste water from a combination oven, dish/ glass washer. commercial sink/basin or any situation where waste water needs to be collected and pumped to the drainage system. 

Pump:

• Safe to run dry

• 10 mm free passage with EIP technology

• Cooling jacket for motor housing

• SiC mechanical seal independent of sense rotation

• Replaceable moisture sealed cabinet inlet

• Flushing Device

• Fluid temperature 35°C, temporarily 60°C (10 mins)

This pump works up to two Rational floor standing ovens SCC/CM 201/202

Tank:
Manufactured from recyclable polyethylene and fully rigged with internal pipe work and non-return valve. The lid is held in place with easy-to-remove hand screws and sits on a custom moulded, fitted rubber seal.

Tank Inlets:
To suit site layout, all inverts should be brought into the side of the tank by drilling a hole and using an appropriate tank connector. Minimum invert height 120 mm.

Tank Outlet:
Fitted 1½” BSP male thread discharge outlet (NRV supplied female thread)

Tank Venting:
To suit site layout, a vent should be taken from the side of the tank by drilling a hole and using an appropriate tank connector. Vent pipe should be 1¼” min. to air or via a Pump Technology MicroVent.

Please refer to the manufacturer data sheet for further information here.