Solo Main Halyard for Super Spars Mast M2 section

Solo Main Halyard for Super Spars Mast M2 sectionSolo Main Halyard for current Super Spars M2 Solo Mast. Rooster Offer 2 types of Solo Halyards, the Rack version or the Lock version. The 'Rack' version is the most common Solo halyard used , where the halyard is held by a toothed rack to hold the halyard tight. The 'Lock' version of the halyard is a special fitting built into the Solo mast approx 400mm from the top of the mast to lock the halyard tight. This halyard has an additional ferrule crimped

Solo Main Halyard for current Super Spars M2 Solo Mast.

Rooster Offer 2 types of Solo Halyards, the Rack version or the Lock version.

The 'Rack' version is the most common Solo halyard used , where the halyard is held by a toothed rack to hold the halyard tight.

The 'Lock' version of the halyard is a special fitting built into the Solo mast approx 400mm from the top of the mast to lock the halyard tight. This halyard has an additional ferrule crimped to the wire to work with the lock fitting.

Both are made from 2.5mm 7 x 19 marine grade stainless steel wire. (Halyard rack version is 6265mm long - bearing surface to bearing surface - including a 250mm wire loop on the end to hook onto the rack - see the photo below).

The current Super Spar exit sheave box is approx 70mm from the heel (lower end point) of the mast step.

Comes with a captive shackle at one and large soft loop at the other for connecting to your hook rack at the bottom of the mast. Including 4mm dia. rope tail.

Typical rack and exist sheave as seen on a Solo M2 mast

Please check this standard Rooster Solo Halyard product is suitable and if required, measure your existing halyard length, as the bottom sheave exit point can vary (or the rack height) on some older Super Spar Solo masts.