Philips Lamp 600W 400V Son-T Pia Green Power

Philips Lamp 600W 400V Son-T Pia Green PowerThis lamp runs at 400 volts and should only be used with 400 Volt 600 Watt HPS Lighting Kits. The Philips Master GreenPower 600W 400 Volt HPS Pro EL Lamp has been designed specifically for Pro HPS 400 Volt 600 Watt lighting systems like our Gavita Pro 400 Volt 600 Watt HPS Complete Lighting Kit . This lamp must NOT be used with any other type of lighting system. When used in a Pro HPS 400 Volt 600 Watt system, this lamp will outperform virtually all

This lamp runs at 400 volts and should only be used with 400 Volt / 600 Watt HPS Lighting Kits.

The Philips Master GreenPower 600W / 400 Volt HPS Pro EL Lamp has been designed specifically for Pro HPS 400 Volt / 600 Watt lighting systems like our Gavita Pro 400 Volt / 600 Watt HPS Complete Lighting Kit . This lamp must NOT be used with any other type of lighting system. When used in a Pro HPS 400 Volt / 600 Watt system, this lamp will outperform virtually all other 600 Watt lamps and lasts for approximately a year!

• A superb lamp, specifically for use with Pro HPS 400 Volt / 600 Watt lighting systems only
• Produces the most umols (plant useable light) of any 600w lamp for flowering
• Biggest yielding lamp 600 Watt HPS lamp available
• Lasts for up to a year

How the Philips Master Greenpower 600W / 400 Volt HPS Pro EL Lamp works:

The Philips Master GreenPower 600W / 400 Volt HPS Pro EL Lamp is a single-spectrum lamp with the most plant-useable light output of just about any 600 Watt lamp on the market. The lamp produces light only in the orange/red part of the spectrum for heavy flowering. It has been specifically designed to make the most of your HPS Pro (400 Volt / 600 Watt) system where it will produce more plant-useable light photons, of a better spectrum, than any other 600 Watt lamp available.

Using the Philips Master Greenpower 600W / 400 Volt HPS Pro EL Lamp:

Using a clean cloth to hold the lamp, screw the lamp into the E40 bulb-holder fitting of your Pro HPS 400 Volt / 600 Watt reflector until it will turn no further. It is important that the lamp is screwed very firmly into the holder. Failure to fit the lamp tightly will cause arcing inside the holder between the centre connector and the contact on the lamp. This will melt the solder contact on the lamp and irreparably damage it. Ensure the lamp is completely clean and free of dirt, grease and finger-prints etc. before switching it on.

WARNING 1: Once the lamp is switched on it runs extremely hot. As with all high pressure sodium and metal halide bulbs it is necessary to avoid touching the lamp with anything such as fingers or plants as this may cause severe burns or fires. In particular avoid sprays or liquids coming into contact with the lamp as this may cause premature failure or even an explosion.

This lamp MUST ONLY be used in a Pro HPS 400 Volt / 600 Watt lighting systems.

Photosynthetic Photon Flux (PPF) output: 1150 umol/s
Kelvin colour: 1960K